I. Introduction to Certification

The CEC certification is the Appliance Efficiency Regulation implemented by the California Energy Commission of the United States in accordance with the law on December 30, 2005. The purpose of implementing this regulation is to enhance the efficiency of electrical products, save energy, reduce gas emissions and the greenhouse effect. This regulation stipulates that electrical products must first comply with the equipment energy efficiency regulations when sold in California, USA. The regulation sets out energy efficiency index requirements, measurement methods, and phased implementation plans for 58 types of electrical products. According to the requirements of this regulation, electrical products must be tested by qualified laboratories in accordance with the corresponding regulations or standards of the United States. Only after being proven to meet the requirements can they be sold in California, the United States.

Ii. Certification Standards

Iii. Test Items

Input current

2. Input power

3. Output voltage

4. Output current

5. Output power

6. No-load voltage

7. Power factor

8. Parameters such as THD

Iv. Required Documents

1. Product name: Provide the full name of the product.

2. Product Model: List in detail all product models, varieties or classification numbers that need to be tested.

3. Intended uses of the product: such as households, offices, factories, coal mines, ships, etc.

4. Parts List: Detail the components and parts that make up the product, their models (classification numbers), rated values, and the names of the manufacturers. For insulating materials, please provide the names of the raw materials.

5. Electrical Performance: For electronic and electrical products, provide point schematic diagrams (circuit diagrams) and electrical performance tables.

6. Structure Diagram: For most products, it is necessary to provide the product's structure diagram or explosion diagram, ingredient list, etc.

7. Product photos, usage instructions, safety precautions or installation instructions, etc.

V. Certification Process

1. The applicant provides product information and pictures;

2. Based on the information provided by the applicant, determine the testing standards and items, and quote to the applicant.

3. Sample testing: Conduct product testing in accordance with CEC certification standards;

4. Issue the report: The qualified laboratory issues the test report.

5.CEC Registration: Submit the materials and data to the CEC registration.

Vi. Certification Cycle and Validity Period

The CEC certification cycle is 1 to 2 weeks

The validity period of the CEC certificate varies depending on the product

Vii. Factory Inspection

CEC certification does not require factory inspection

Viii. Certification Mark

no